2.
Press the DIMM
gently but firmly straight down into
the socket until they are fully inserted. When the
DIMM module is fully inserted, it is held in position
by a retainer clip located on the end of the socket
nearest the back of the computer.
3.
Repeat this procedure to install a DIMM in the other
bank.
4.
Replace the cover of the computer.
Installing Internal Drives
There are seven drive bays in your SuperMac C600. Counting from the
top of the computer, bay 1 contains the factory-installed CD-ROM
player. Depending on the specific C600x model you have, bays 2 and
3 may contain a removable media drive, such as a Zip drive. Bay 4 con-
tains the floppy disk drive, bay 5 contains the IDE hard disk, and
bays 6 and 7 are empty.
All additional drives must be SCSI drives, not IDE drives. All devices
on the internal SCSI chain must have unique ID numbers from 0 to 7.
On the internal SCSI chain, the computer itself has the ID number 7,
and the factory-installed CD-ROM player has the number 3.
IMPORTANT:
Set the SCSI ID for your additional drive before you install it in
your computer. See the manual that came with your drive for instructions.
To ensure accurate transmission of information, a terminator must be
at each end of a SCSI chain. The main logic board, which is the first
device in the chain, has a built-in terminator. The CD-ROM drive,
DIMM socket
Retainer clip
