-3-
RECEIVER PROGRAMMING
-4-
SYSTEM SETUP
Note:
Transmitting devices such as cellular phones and two-way radios
may interfere with wireless audio transmissions. Keep your transmitters
and receivers away from these and other potential sources of
interference.
Automatic Transmitter Setup
1. Tur n on transmitter.
2. Open transmitter battery cover to display the infrared (IR) port.
3. Point transmitter IR port to receiver IR sensor.
4. Press “SYNC” button on receiver. Transmitter will be
set to be same group and channel as receiver automatically.
Antenna signal will display in receiver screen.
5. Close the transmitter battery cover.
Be sure that only one transmitter IR port is exposed when
synchronizing a system.
Turn on receiver.
Channel Selection
1. Press “MENU” button to move cursor to “GROUP SELECT”.
2. Then press “SET” button to increase the group number by one.
3. When the desired group is displayed, either wait five seconds for
the screen to time out, or press “SYNC” button.
1. Press “MENU” button again to move cursor to “CHANNEL
SELECT” .
2. Then press “SET” button to increases the channel number by one.
3.When the desired channel is displayed, either wait five seconds for
the screen to time out, or press “SYNC” button.
Group Selection
MULTIPLE SYSTEM SETUP
SINGLE SYSTEM SETUP
When using multiple systems in a single installation, repeat steps in
SINGLE SYSTEM SETUP
to set up each system.
Please set multiple systems in different group and/or channel to avoid
interference.
1. Interchangeable microphone head
2. Power/Mute indicator: Green-ready; Orange-mute on;
3. On-off / mute switch: Press and hold 1~2 seconds to turn microphone
on or off. Press shortly to mute or unmute.
4. Battery cover/compartment
5. IR port: Receives infrared beam from receiver to synchronize
frequencies.
6. Charging port
HANDHELD MICROPHONE PARTS DESCRIPTION
1. Antenna
2. Power/Mute indicator: Green-ready; Orange-mute on
3. On-off / mute switch: Press and hold 1~2 seconds to turn on/off
transmitter. Press shortly to mute or unmute.
4. MIC input Jack
5. IR port: Receives infrared beam from receiver to synchronize
frequencies.
6. Battery compartment
7. Charging port
8. Belt clip
BELK PACK TRANSMITTER PARTS DESCRIPTION
1
2
3
4
5
6
1 2
3
4
5
6
7
8