02
EVA BULLET TURREt
FUNCTION INSTRUCTIONS
Eva Bullet
Turret *1
Ammunition
Clip *1
Infrared Ray
Equipment *1
Eva
Bullet *1
1. Put eva bullet into
ammunition clip.
3. Connect the turret wires to the vehicle’s wire ports (lift the clip on the port
and insert the connector fully, then release the clip). Next, to connect the EVA
Bullet Turret, there is an emboss on the side of the turret connection port
on the vehicle, place the tooth of the EVA Bullet Turret into the emboss
while pressing the side button (image above) so you can clip the tooth
into the vehicle emboss. To disconnect, press the side button to pull out
the EVA Bullet Turret. Once the Turret is out, disconnect the wires by
lifting the clip on the port and pulling out the connected wire clips.
2. There is an arrow mark on the ammunition clip,
the arrow must face to the slot in the middle of the
turret. To remove the clip, lift it up out of the turret.
4. Attach the infrared ray equipment to the turret, remove the
white tag, and press press the switch to turn on the laser.
5. After successful frequency connection (refer to Part 5 on Page
1.), use the turret buttons to turn the EVA Bullet Turret left and right.
6. Turret Shooting Function: Press the Turret Shooting button to shoot the
EVA bullets. If you press and hold the button, the turret will continuously fire.
P A R T S L I S T
Turret Turn
Right
Turret Turn
Left
Turret Shooting
