2. Open the cover on the top of the turret and pour
the water bullets into the chamber, the close the
top. After you’ve finished playing with the toy,
remove the remaining water bombs and clean the
chamber. DO NOT Add water when adding the
water bombs, as this could cause a short circuit.
3. Connect the turret wires to the vehicle’s wire ports (lift the clip on the port
and insert the connector fully, then release the clip). Next, to connect the EVA Bullet
Turret, there is an emboss on the side of the turret connection port on the vehicle,
place the tooth of the WATER Bullet Turret into the emboss while pressing the
side button (image above) so you can clip the tooth into the vehicle emboss.
To disconnect, press the side button to pull out the WATER Bullet Turret.
Once the Turret is out, disconnect the wires by lifting the clip on the
port and pulling out the connected wire clips.
1. Place water bullets into the
container and add water. Let is
sit for 5minutes. Filter out the
excess water from the container
after the 5 min are complete
(be careful not to lose bullets).
Infrared Ray
Equipment *1
Water Bullet
500 units
Water Bullet
Container *1
Water Bullet
Turret *1
P A R T S L I S T
WATER BULLET TURRET
FUNCTION INSTRUCTIONS
03
4. Attach the infrared ray equipment to the turret, remove the white
tag, and press press the switch to turn on the laser.
5. After successful frequency connection (refer to Part 5 on Page 1.),
use the turret buttons to turn the WATER Bullet Turret left and right.
6. Turret Shooting Function: Press the Turret Shooting button to shoot the WATER
BULLETS. If you press and hold the button, the turret will continuously fire.
Turret Shooting
Turret Turn
Left
Turret Turn
Right