3. Connect the turret wires to the vehicle’s wire ports (lift the clip on the port
and insert the connector fully, then release the clip). Next, to connect the EVA
Bullet Turret, there is an emboss on the side of the turret connection port on
the vehicle, place the tooth of the Bubble Turret into the emboss while
pressing the side button (image above) so you can clip the tooth into the
vehicle emboss. To disconnect, press the side button to pull out the Bubble
Turret. Once the Turret is out, disconnect the wires by lifting the clip on the
port and pulling out the connected wire clips.
6. Turret Shooting Function: Press the Turret Shooting button to shoot the WATER
BULLETS. If you press and hold the button, the turret will continuously fire.
5. After successful frequency connection (refer to Part 5 on Page 1.),
use the turret buttons to turn the WATER Bullet Turret left and right.
2. Open the back door of the Bubble Turret, pull out the two hose inside the
turret magazine and insert them though the holes of the cap of the bubble water
container as far as possible. Put the container into the magazine of the turret (as
shown in the figure above). After you’ve finished playing with the toy, remove the
container from the magazine and clean the magazine.
1. Pour bubble water into the
bubble water container and
close the cap tightly.
Bubble Concentrated
Solution *2
Bubble Water
Container *1
Bubble
Turret *1
P A R T S L I S T
bubble BULLET TURRET
FUNCTION INSTRUCTIONS
04
Turret Turn
Left
Turret Turn
Right
Turret Shooting
