UnderCover 2110, Installation Manual

Mounting the Ball Stud for your hydraulic strut is simple and easy. 

Page 6, Picture A

 shows 

what the finished install will look like.

In the center of the bed there are two torx bolts, you will need to remove the one towards 

the rear of the truck. You will need a Torx T-30 bit to remove this bolt.  See 

Page 6, Picture B

. 

Again, like the plastic tabs from the rear mounting bracket proceedure, you should save this bolt 
for removal of brackets in the future.

Once you have removed the torx bolt you can now hand thread the ball stud included 

with the hardware. Secure the ball stud with a 1/2" wrench or socket/ratchet. BE SURE NOT TO 
OVER TIGHTEN. DOING SO CAN SHEAR OFF THE BALL STUD AND CAUSE SERIOUS DIFFICULTY 
CORRECTING.

Once you UnderCover is installed you will be able to lift the cover up and clip the strut to 

the ball mount. See 

Page 6, Picture C

.

A

B

C

D

WARNING!  Be sure not to over tighten the rear mounting bolts. Doing so could shear 
off the bolt heads, creating a difficult procedure to remove the remaining thread.

FORM # IG2110HH

Modified Mar 2009

Page 5

Model 2110 Ford Explorer Sport Trac 2007-Current