![background image](http://html1.mh-extra.com/html/underhill/tracker/tracker_assembly-instructions-and-operation-manual_3627031007.webp)
Underhill Tracker Assembly and Operation Instructions
7
Once the wheels are installed, attach the 4 (gray) hubcaps as shown in Figure 7-1.
Installing Hubcaps
Figure 7-1
Assemble and Install The Water Supply Fittings
Locate the 1” brass threaded inlet on the back of the Tracker. Wrap the male threads of
the 1” brass, male to female quick-connect with Teflon tape and thread into this inlet,
see Figure 7-2. Hand-tighten, then ¼ turn further with a crescent wrench to prevent
leakage.
Thread Brass Quick Connect into Tracker Inlet
Figure 7-2
The mating connector to this quick connect has a 1” female hose thread (FHT) to attach
to a 1” diameter hose, See figure 7-3.
1” Female Hose Thread
Figure 7-3