UL Ti MATE 70 316L Stainless Steel
3DUW'HVFULSWLRQ
3DUW1R
1: Projector cable
S00111
2: Projector lid complete
S00C102
3: "O" Ring
00108
4: Projector case
00101
5: Lamp (150w HQI)
91205
6: Reflector
91791-1A
7: Connecting ring
000C03
8: Gaskets
000C07
9: S.S. M6 socket screws
93334
10: Glass retaining ring
00304-70A
11: Gaskets
00278-A
12: Glass
00280-70A
13:Electronic ballast-100/277v S00800-V1W2
/(16),77,1* ,16758&7,216
Check the glass landing surface is clean and apply a suitable silicone grease to the gaskets. Fit
the glass, gaskets and retaining ring as shown above. Hand tighten the screws with a 5mm
Allen key making sure the glass retaining ring is square. Torque the screws to
Nm (
.
ft/lbs)
in the sequence shown, check the ring again and re-torque the screws again to the same setting.
ORDERING NUMBERS FOR 100-277 VOLT 150 WATT LIGHTS
FLUSH - S00310-70A-V1, 20 DEGREE - S00320-70A-V1,
24-38 DEGREE - S00338-70A-V1, 50 DEGREE - S00350-70A-V1
FLUSH - S00310-70A
20 DEGREE - S00320-70A
24-38 DEGREE - S00338-70A
50 DEGREE - S00350-70A
1
2
3
4
5
6
(/(&75,&$/ ,1)250$7,21
Cable specification from electronic ballast to projector (Pt.No. S00111)
Shielded 3 core, Temperature -60C to +180C, Voltage 2000 volts.
Maximum distance between ballast and projector with the shield
earthed 10 meters.
Ballast power 100/277 volt 150 watt ballast - running current 2.0/07.A
Ballast will not ignite a hot lamp. The ballast has a cycle
of three atempts to ignite the lamp then will wait for four
minutes before repeating the cycle.
5HFRPPHQGHG6SDUHV
3DUW1R
Lamp (150w HQI)
91205
Glass with gaskets
S00C01-70A
Electronic ballast
95322
The UL Ti MATE is serviced from inside the hull. Allow
access for maintenance and space for ventilation.
Do not use the UL Ti MATE in dry-dock or out of the water
Allow a minimum of 70mm behind the projector lid
(item 2) for lamp replacements.
UL Ti MATE to be fitted 250mm below the yachts water
line when loaded with 50% fuel and 50% freshwater onboard.
Do not attempt to remove the glass lens while afloat.
The projector must be correctly assembled with lid
secured to the UL Ti MATE 70 whilst afloat.
23(5$7,21$/ &21',7,216$1'&216,'(5$7,216
ELECTRONIC BALLAST COMPLETE WITH IP65
ENCLOSURE -S00800-V1W2 (V1=100-277 VOLTS, W2=150 WATTS)
PLEASE REGISTER YOUR PRODUCT WARRANTY DIRECT TO
:::5(*,67(58:/&20
FOR TECHNICAL INFORMATION PLEASE EMAIL
7#81'(5:$7(5/,*+76&20
SALES, PRODUCT INFORMATION AND NEWS GO TO
:::81'(5:$7(5/,*+76&20
Ul ti mate 70 SS
(41/61
