47/('
/('
5(7528/7L0$7(
,QVWUXFWLRQVIRUFRQYHUWLQJWKHRULJLQDO8/7L0$7(UDQJHWR47/('
7KHIROORZLQJSURFHGXUHLVDFKLHYHGIURPLQVLGHWKHKXOO
7KH³(;,67,1*/,*+7´SDUWVLQGLFDWHGEHORZVKRXOGQRWEHUHPRYHG$OORWKHUSDUWVPXVWEHFDUHIXOO\UH
PRYHG7KRURXJKO\FOHDQWKHJODVVOHQVDQGWKHLQVLGHRIWKHOLJKWEDUUHO
*Check that the LED heat sink (1) slide into the existing barrel and land on the glass retaining ring. Remove item and
check that the existing connecting screws onto the barrel. With these parts successfully checked for fi tting follow the
assembly procedures below.
*
$VVHPEO\SURFHGXUH
-Use silicone grease to lightly coat the heat sink (1), clamp ring (3) and sealing ‘O’ rings. Slide
the heat sink (1 ) into the barrel and tighten the knurled securing clamp ring (3) to secure the heat sink (1) into the body.
When the heat sink (1) cannot be rotated the clamp ring (3) has secured all in place. If this is not done it will cause
overheating of the LED and the LED could fail.
*Caution: do not operate lights unless totally submerged.
*
(OHFWULFDOLQVWDOODWLRQ
The QT 80 retro is supplied with 2 meters of cable ready for connection into the IP 68 fused
enclosure also supplied.
*The fused enclosure connection terminal have a higher rating than 20 amps but we strongly advise a maximum supply
current to the enclosure of 20 amps.
*When the fused enclosure is used for distribution to the underwater lights the 10 amp fuse must be used to protect the
out-going supply cable to the lights.
7(&+1,&$/63(&,),&$7,21
6XSSO\9ROWDJH
11-28vdc Maximum current at 11vdc =
DPSV
3RZHU
40 watts
/(''ULYHU
- Integral-
<(6
/('
Cool white (6,
00 lm)
%OXH
%2'<0DWHULDO
1LFNHOSODWHG
$%%URQ]H
& 5083 Aluminium
/('ODPSOLIH
20,000 hours @ 60° C
&YJTUJOHMJHIU
($57+6&5(:
,7(0
5(752,167$//
Z
ZZZXQGHUZDWHUOLJKWVFRP
7+(47/('5$1*(,6'(6,*1('$1'0$18)$&785('%<81'(5:$7(5/,*+76/7',17+(
8.
