Installation:
Select a location that affords good access to the ballast box. Preferably the ballast box should be placed in a cool, dry and well
ventilated area. Attach the ballast box to a fixed wall or similar secure structure using appropriate M6 fasteners. Note: Whereas,
the ballast box can be placed in any orientation, it is recommended that the cable strain relief connectors face down.
Using marine grade cable, run a VAC input line into the ballast box and secure by way of one cable strain relief connector.
Using a high temperature 18/3 shielded silicone cable, run a line from the ballast box to the underwater light and secure each end
by way of a strain relief connector. Caution! Avoid making tight bends and/or passing cable over sharp edges/surfaces.
Connect cable leads at both the ballast box and underwater light as shown in the wiring diagram below.
Serviceable Parts:
Upon opening the ballast box by unscrewing four captive lid fasteners, replacement of the HID ballast and/or terminal block with
fuse is accomplished by removal and replacement of three phillips pan head screws and associated wiring. Further, a 10 Amp fuse
located in the fused terminal block may be pulled out and replaced as required. Caution! Ensure that VAC power is disconnected
and locked out before servicing ballast box.
SV18 Ballast Box
120VAC/150W
240VAC/150W
Underwater Lights Europe Sarl
16, rue Rouaze
06400 Cannes, France
Phone: 33-(0)-4-97-21-02-96
Fax: 33-(0)-4-97-21-10-96
Internet: www.seavision.com
Underwater Lights USA, LLC
3406 SW 26th Terrace, C-6/7
Fort Lauderdale, FL 3331
2
USA
Phone: 1-954-760-4447
Fax: 1-954-525-3261
Internet:
www.seavision.com
Email:
sales@seavision.com
DOC:092005-11
Email: sales@seavisioneurope.com
FAST BLOW FUSE
18013
M3.5 x 0.6 x 12LG PPHS
18011
M4 x 0.7 x 8LG SST PPHS
18010
M6 x 1.0 x 8LG SST PPHS
18009
FUSED TERMINAL BLOCK
18008
240VAC BALLAST, MODEL 11A16B
18007
120VAC BALLAST, MODEL 10A16B
18006
BLANKING PLUG
18005
CABLE STRAIN RELIEF
18004
TERMINAL BLOCK MOUNT
18003
MOUNTING PLATE
18002
ENCLOSURE, PLASTIC
ENCLOSURE, ALUMINUM
18001
18020
DESCRIPTION
PART
120VAC BALLAST, MODEL 10A19B
18017
240VAC BALLAST, MODEL 11A19B
18018
16/3 HIGH TEMP SHIELDED SILICONE ELEC CABLE
18019
MODELS 10A16B & 10A19B, 120VAC/150W
MODELS 11A16B & 11A19B, 240VAC/150W
8-18 x 6LG THREAD FORMING SST PPHS
18021
GROUND WIRE ASSEMBLY
18022
