PLEASE READ BEFORE INSTALLATION.
•
When installed in accordance with these instructions, the front protection bar does not affect the
operation of the vehicles SRS airbags.
•
This product must be installed exactly as per these instructions using only hardware supplied.
•
Take a few moments to read instructions thoroughly before beginning work.
•
In the event of damage to any bar component please contact Uneek 4x4 in regards to
repair/replacement of components.
•
Do not use this product for any vehicle make or model other than that specified on these
instructions.
•
Do not remove labels from this product.
•
This product and its fixings must not be modified in any way unless stated in these fitting
instructions.
•
The installation of this product is recommended for trained personnel.
•
These instructions are correct at time of publication. Uneek 4x4 cannot be held responsible for the
impact of any changes subsequently made by the vehicle manufacturer.
•
During installation it is the duty of the installer to check correct operation/clearances of all
components.
•
Supplied tow points are designed as tow points only. Use in a recovery operation will be at
operator’s risk.
•
Installation time: 4-5 hours.
•
Vehicle specific notes: A flip up license plate kit may be required. Optional Narva 90862 license
plate light.
FASTENER TORQUE SETTINGS:
M6
–
9Nm (4lb ft)
M8
–
22Nm (16lb ft)
M10
–
44Nm (32lb ft)
M12
–
77Nm (57lb ft)
TOOLS REQUIRED:
BASIC TOOL KIT: Soldering iron or electrical in-line connectors.
Male and female spade terminals.
Drill and drill bits up to 12mm.
EYE & EAR PROTECTION REQUIRED
DRILLING REQUIRED
TWO PERSON LIFT REQUIRED
TORQUE SETTING
CUTTING OR GRINDING REQUIRED
Summary of Contents for HC-FB-CW2016-ASMO
Page 1: ......
Page 2: ......
Page 13: ......
Page 14: ...20 Gateway Drive Carrum Downs VIC 3201 1800 806 952 www uneek4x4 com au Revised 25 07 2019...
