Unex 550536, Installation Manual

Regulatory  Information 

The manufacturer is not responsible for any radio or television interference caused by unauthorized 
modification of this device or the substitution or attachment of connecting cables and equipment other than 
specified. The correction of interference caused by such unauthorized modification, substitution or 
attachment will be the responsibility of the user. Built-in antennas, whether installed indoors or out, should be 
installed only by experienced antenna installation professionals who are familiar with local building and safety 
codes and, wherever applicable, are licensed by the appropriate government regulatory authorities. 
 
FCC Radiation Exposure Statement 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.  
This equipment should be installed and operated with minimum distance 20cm between the radiator & your 
body.  

USA – Federal Communications Commission (FCC) 

This equipment has been tested and found to comply with the limits for Class

B

Digital Devices, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instruction, may 
cause harmful interference to radio communications, However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following 
measures: 

- 

Reorient or relocate the receiving antenna 

- 

Increase the separation between the equipment and the receiver 

- 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.  

- 

Consult the dealer or an experienced radio/TV technician for help. 

Canada – Industry Canada (IC) 

This class B digital apparatus meets all requirements of the Canadian Interference Causing 
Equipment Regulations.  

EU Declaration of Conformity (Europe) 

USB adapter conforms to the specifications listed below, following the provisions of the Low Voltage 
Directive 73/23/EEC and the EMC Directive 89/336/EEC  

ETSI              ETS 300 328 

                       ETS 300 826 

Safety EN60950/IEC950