4
•
Do not use the machine if you feel dizzy or week.
•
Any modifications or improvements to the machine are strictly prohibited. If you discover any cracks or
damages to the machine, do not use.
•
Never perform any maintenance during operation.
•
If you see any unusual sign or hear any strange sound, switch of machine immediately.
•
Do not forget to remove all wrenches and screwdrivers from the machine after use.
•
Before use, make sure all screws are tightened securely.
•
Perform maintenance regularly. Before use make sure the machine is in good working conditions and
without any damage.
•
Use only original spare parts during repairs.
•
Using accessories of extension pieces not approved by the manufacturer may cause personal injuries.
•
Use this machine only for work that could be handled by it. Do not overload tools, accessories or the
machine. For large work volume use more powerful machine.
•
Do not overload the machine. Measure the work load in such way, so it could be done with comfortable
speed. Damages due to machine overload are not covered by the warranty policy.
•
Do not expose to extremely high temperature or direct sunlight.
•
This machine is not designed for use in humid environments or under water.
•
If you are not using your equipment, store it in a dry and locked place, out of reach of children.
•
Before use, inspect all safety elements and make sure they work as designed. Make sure all moving parts
are in good working conditions.
•
Inspect all parts for cracks and damages. Make sure movable parts are not stuck and set properly. Also
take into consideration other conditions that may have a negative effect on the proper function of your
machine.
•
If not stated otherwise in this manual, all damaged parts and safety elements must be repaired or
changed.
Fine mechanics
•
Never use a vise to hold your machine.
•
Protect your machine from fall and impact. After work store all tools and equipment back to the briefcase.
Assembly
•
Do not use the machine unless completely assembled.
Automotive repair shop equipment
•
Before performing any maintenance, shift the gear into neutral, apply the vehicle hand break, or use other
means to prevent the vehicle form accidental move.
5
???
•
Before throwing the packaging material out, make sure no part is left inside. If so, take it out and install it.
Use the part listing for check-up and the installation drawing for guidance.
•
The spindle must be screwed inside the nut all the
way.
•
For pressing operations use spindle extension
pieces and not only the surface of the spindle.
•
Jaw teeth must fit inside the nut groove (for two and
three arm heads).
The pulling force is transferred via the jaw
toothed gear and not buy the screws. These
serve as a auxiliary aid and make the use of
the puller easier.
•
Nuts that hold the jaws inside the head may be
tighten by hand only, so they are securely attached
and you will not lose them.
•
Columns or their extension pieces must be tighten
inside the lower jaws and also the pulling screws
of the jaws must be securely fastened to prevent
damage to the column threading.
•
To fasten the columns in the upper cross arm use
nut and washer assembly.
•
Steel jaws may be used in both positions - they are
equipped with continuous go-through-threading.
Detailed description of the use of this device
is not included in this manual, because the
manufacturer / distributor assumes that the user is
experienced in similar type of work. Also according
to the applicable law, this device is considered as
a commonly sold and used tool. If the user
is unfamiliar with the use of this device, we
recommend finding out more information about
using this device at the Department of work safety.
ASSEMBLY
OPERATION
