MANUAL - UG4000-6000 UPP6500E and UP6000
REVISION 2014-09
6
SOLVENT SELECTION
The adhesion quality of automotive paint has dramatically
improved in recent years. The choice of solvent is critical. Only
use good quality solvent that is formulated for your paint and
intended for use with automatic spray guns cleaners.
SOLVENT PAIL SETUP
For Units Where One or Both Pails are Not Included
•
Open the door to the base cabinet
•
Move the Drain Valve handle to the "closed" (horizontal)
position if it is not already there. See picture on right.
•
Two 5-Gal (19 L) pails of solvent are required, one full and one containing 3 gal. Place the pails
in front of the machine, full pail on the right and the other pail on the left.
•
Inside the cabinet you will see two pipes strapped together, the Suction Pipe and the Rinse
Pump. Cut the strap holding them together. Do not cut the other straps holding the black and
blue tubes.
•
Disconnect the Suction Pipe from the Drain Valve by pushing the gray button and bring both
pipes outside of the cabinet.
•
Insert the Rinse Pump into the full pail on the right and the Suction Pipe into the pail with 3 gal
on the left. Models with a Manual Wash brush also have a tube to supply the brush. The tube
Drain Valve
PAIL NO.2
WASH SOLVENT
780-8110P
MANUAL WASH
SUCTION TUBE
DRAIN HOSE
PAIL NO. 1
CLEAN SOLVENT
780-8120P
MANUAL RINSE
SUCTION TUBE
GROUND WIRE (GREEN)
GROUND WIRE
(GREEN)
TRANSFER HOSE
OUTGOING
CONNECTION
RINSE PUMP
(URP100S-F) WITH
BLUE AIR LINE
SUCTION HOSE
RISER
780-8116F
(E-MODELS ONLY)
OVERFLOW TUBE
750-815P
(E-MODELS ONLY)
TRANSFER HOSE
INCOMING CONNECTION
(E-MODELS ONLY)
PAIL SETUP
DRAIN VALVE
