MANUAL - SPRAY GUN CLEANERS - UG5000W SERIES
Revision 2019-3
14
CLEANING
CYCLE
• Close the lid of the spray tank and turn the "Auto Wash Timer" clockwise to start cleaning as in photo below.
The wash cycle takes about 60 seconds. Solvent flows from the wash pail.
• Push and hold the "Air Rinse" button for about 2 seconds to evacuate the wash solvent. See photo below.
• Press and hold the "Clean Rinse" buttom for about 2 seconds to send 100 cc of clean solvent through the jets
to rinse the the spray guns, see the photo below. Clean-rinse is limited to 100 cc to minimize clean solvent
consumption. Wait 30 seconds for the Rinse Pump to fully recharge before re-pressing the Clean Rinse button.
Push and hold the "Air Rinse Control" button for about 2 second to air-rinse the guns.
•
After cleaning the spray guns, remove the guns and cups from the tank and wipe them dry. Do not
store spray guns and cups in the wash tank.
USING THE FLOW-THROUGH BRUSH
•
To deliver wash solvent through the Brush for washing, (see left photo below) step on the foot
pedal.
•
Solvent flow is set at the factory but may be adjusted using the "Brush Flow Control".
See the photo below.
• To increase flow, loosen the locking nut, rotate the dial anti-clock wise, then tighten locking nut.
USING CLEAN SPIGOT
Timer
Air Rinse
Clean
Rinse
Flow through brush
Flow Control Flow Control
Water Gun
Brush
PUSH
PUSH
