MANUAL - SPRAY GUN CLEANERS - UG7500 SERIES
REVISION 2011-05
8
•
Rinse cup with solvent and pour into the same 5 gallon pail for later disposal or recycling.
CLEANING SPRAY GUNS AND CUPS
•
Loosen the air cap of the spray gun two full turns.
•
Lock the trigger in the open position with the Trigger Lock Spring.
•
To prevent liquid from entering the air passgae during automatic clean-
ing, insert the white plastic Air Passage Plug into the Spray Gun's air
inlet. If the air inlet has a male threaded connector instead of a quick
connect use the knurled nut attached to the Trigger Clamp (included).
SELECTION OF NOZZLE EXTENSION
780-3530
INSTALLED. HOLES PROVIDE SOLVENT TO CEAN DISPOSABLE CUP ADAPTOR.
CANNOT BE USED FOR CONVENTIONAL SYSTEMS.
110-43099S HOLES PROVIDE SOLVENT TO CLEAN DISPOSABLE CUP ADAPTOR. MAY ALSO
BE USED FOR CONVENTIONAL SYSTEMS WITH LARGER OPENINGS IN NECK OF
CUP.
110-430
FOR CONVENTIONAL SYSTEMS ONLY WITH SMALLER OPENINGS IN NECK OF
CUP.
CLEANING SPRAY GUNS AND CUPS (except for “NG” model)
•
Place spray guns facing corner jets. Placement depends on
type of spray gun
. See pictures.
Place cups onto the low spray jets and cup holders.
• Close the lid and turn the “Auto Wash Timer” knob clockwise to start cleaning. The cleaning takes
about 60seconds
•
Push and hold the "Air Rinse" button for about 3 second to air-rinse the guns.
•
Push and hold the "Clean Rinse" button for about 5 seconds to rinse guns with clean solvent. This
will send a pre-set amount of clean solvent (100 cc) through the jets. Wait 30 seconds for the
Rinse Pump to fully recharge before repeating.
The
s
olvent flow per clean-rinse cycle is limited to 100 cc to minimize consumption. This quantity
is usually sufficient to clean the inside pasages of the spray guns.
USING THE MANUAL WASH and RINSE
Manual Wash Brush (used solvent)
•
Step on the manual wash pedal. A dedicated pump delivers wash (used) solvent through the
brush.
Manual Rinse Spigot (clean solvent)
•
Step on the manual rinse pedal. Clean solvent is delivered through the spigot.
SPRAY GUN TESTING - LE model only (see picture on page 4 or 14)
•
Connect the Spray Gun to the Air Supply Outlet and turn on the Air using the Air On/Off lever.
•
Check the air pressure on the Pressure Gauge. Using the Pressure Regulator (inside the cabinet
on the right), adjust the pressure according to the requirements of the Gun (pre-set value is 15-25
PSI).
•
Test the Gun and turn off the Air when finished.