9
MANUAL - SPRAY GUN CLEANERS - UG7500 SERIES
REVISION 2011-05
HOSE CLEANING - FACTORY OPTION (except “NG” model))
•
This feature can be used to clean a paint feeder hose up to 100 feet (30 m) long. Connect the
hose to the two fittings, one on the lid and one on the right side. Rotate the "Mode Selector" han-
dle to the horizontal position and turn the Timer knob clockwise to start the automatic cleaning
cycle.
AFTER CLEANING
•
Remove the guns and cups from the tank and wipe them dry. Do not store spray guns in the tank.
CONNECTING TO A SOLVENT RECYCLER
•
On the back of the machine, connect the Transfer Hoses to the Solvent-In and Solvent-Out con-
nectors.
DAILY MAINTENANCE
FILTER PADS AND SCREEN
•
Inspect the filter pad in the bottom of the cleaning tank and, if there is a build up of paint debris,
clean the pad by removing it from the tank and washing away the paint debris.
REPLACING SOLVENT
•
Disconnect the Suction Pipe from the Drain Valve and remove the pipe from the pail. Move the
pail out of the cabinet and recycle or dispose of the dirty wash solvent. .
•
Place a new, full-pail of clean solvent in front of the cabinet.
•
Move the pail into the cabinet and re-connect the Suction Pipe to the Drain Valve.
