12) Indicator Light
Description
<36V
50V~1000V (the red indicator light flashes from slow to fast)
OL
No continuity (
≥
70Ω)
Continuity (<50Ω)
>2V
Breakdown (<0.12V)
Conduction (0.12V~2V)
≤
1000V
>1000V
≤
10A
>10A
The temperature in the meter drops to <40°C
after measurement of large current.
The temperature in the meter is
≥
75°C
after measurement of large current.
Status
Off
On, red
Off
On, red
On, green
Off
On, red
On, green
Off
On, red
Off
On, red
Off
On, yellow
Function
NCV
Continuity
Diode
AC/DC
voltage
Current
Internal
temperature
during AC/DC
current
measurement
Warning: Before opening the rear cover or battery cover of the meter,
switch off the power supply and remove the test leads.
1. General Maintenance
2. Battery/Fuse Replacement (Picture 18b)
The contents of this manual are subject to change without prior notice.
Picture 18a
Picture 18b
X. Maintenance
RANGE
10A
≤
1
Ω
≤
1Ω
OL
OL
√
х
≤
20MΩ
mA
µ
A
35
36
1) Clean the meter casing with a damp cloth and mild detergent. Do not use
abrasives or solvents!
2) If there is any malfunction, stop using the meter and send it for maintenance.
3) The maintenance and service must be implemented by qualified professionals
or designated departments.
4) Resistance measurement can be used to check the built-in 600mA and 11A
fuses. Operation (Picture 18a): Insert the red test lead into the or
terminal.Insert the red probe into the
mA/
μ
A
input terminal to measure the
resistance. If the LCD displays “OL”, the 600mA fuse is blown. Insert the red
probe into the
A
input terminal to measure the resistance. If the LCD displays
“OL”, the 11A fuse is blown.
Battery: 4×1.5V AAA batteries
Fuse: F1 Fuse 600mA 1000V Φ6x32mm (mA/μA input terminal)
F2 Fuse 11A 1000V Φ10x38mm (A input terminal)
When “ ” is displayed, please replace the batteries in time to ensure
measurement accuracy.
Replacement steps:
1) Turn the function dial to the "OFF" position, and remove the test leads.
2) Unscrew and remove the battery cover to replace the batteries and fuses.
