19
20
between the set time intervals (detailed in menu function set). If automatic
record count exceeds the maximum record count 1999, it shall exit data
storage automatically.
8
Check record data
Press key REND to enter into check record data mode, if no storage data,
data value on LCD screen display area display
---
data record number
display area display
---
and enter into test function after about 0.5 second.
If any storage data, it shall display the last data and record number; press
key
to reduce record number and its corresponding storage data; Press
for a long time to automatically reduce them. Press key
to increase
record number and corresponding storage data, press it for a long time to
increase them automatically. Press REC to display increase by 100, if record
count is less than 100 or exceed maximum record count 1999, it shall back to
the first record number and corresponding storage value; press REC to back
to the first record number and corresponding storage value. Under the mode,
only the above keys and can be used except for others. Press the key to
exit the mode.
9
Delete record data:
Method1: before start machine, press key CLEAR and POWER in the same
time, stop pressing key POWER until LCD screen display CLR, record
deletion has been completed.
Method2: restore factory setting (detailed in menu function setting)
10
Menu function set:
Press key MENU to enter into menu function set with fault status USB0,
which indicates failure to conduct USB communication, press key
or
to
change USB setting, LCD screen shall display indicator of USB and USB1
indicates being able to conduct USB communication; Under menu function
set mode, press key READ, LCD display USB1 flickering, after memory data
transmitted to computer, press key ENTER to save and enter into next menu
---set automatic power-off AP01, which indicates automatic power-off function
