UT3500 series
User Manual
27
Setting Steps:
1. Press the [Test] key to enter the <TEST> page or press the [Setup] key to enter the
<Setup> page;
2. Use the cursor key
▼
to move the cursor to the [SPEED] field;
3. According to your own needs, use the function keys at the bottom of the screen to
select the desired test speed.
4.2 Manual Save and View Data
The measured display value can be manually saved (up to 500 sets of data can be stored)
and quickly browsed on the instrument screen. Press the function key [MANUAL SAVE] at
the bottom of the screen to manually save the data. Each time you press the key, the data
will be saved manually. Via the function key [VIEW DATA], you can view the manually
saved measurement data on the instrument screen, as shown in Figure 4-2-1.
Figure 4-2-1 <VIEW DATA> Page
On the <VIEW DATA> page, you can also use the function keys at the bottom of the screen
to perform the following operations on the data:
Save to USB Disk: After inserting the U disk, this function key can save the data in the
U disk.
Clear: This function key can clear all data.
Page Up/
Page Down/
Jump to: This function key can realize the page up and down
or jump of multiple pages of data.
Set [Unit of Resistance] Display Mode:
Use the right arrow key to move the cursor to [R-UNIT]. There are five display modes for
selection: AUTO, m
Ω
,
Ω
, k
Ω
, SCI. NOTE. (refer to
If you want to delete a row of data, you can press the arrow keys to stop the cursor on a
specific row, and select the [DELETE] function key at the bottom of the screen to delete
