UT3500 series
User Manual
45
the bottom of the screen to enter the <SYSTEM CONFIG> page;
2. Use the cursor keys to move the cursor to the [ADDRESS] field;
3. According to your own needs, press the function keys at the bottom of the screen to
select different addresses from 01 to 15.
In order to facilitate the simultaneous operation of multiple identical instruments, the
instrument allows using the address 00 for broadcast communication. Using address 00
for communication, the instrument only receives commands and cannot return response
codes.
8.1.9 [End Mark], [Hand Shake], [Error Code] Setting
The instrument RS-232 uses SCPI language for programming. To use the SCPI protocol,
please set up SCPI first. There must be an end mark in the communication command
between the instrument and the host to facilitate mutual recognition of the end of the
command.
The instrument supports the following end marks:
End Mark
ASCII Name
ASCII Hexadecimal Bytes
Description
LF(0x0A)
Newline
0x0A
1 Byte
Instrument
Default
CR(0x0D)
Carriage Return
0x0D
1 Byte
CR+LF
Carriage
Newline
The First Byte
0x0D
2 Bytes
The Second Byte
0x0A
NUL(0x00)
Null Character
0x00
1 Byte
Setting Steps:
1. Press the [Test] or [Setup] key, and select [SYSTEM CONFIG] with the function key at
the bottom of the screen to enter the <SYSTEM CONFIG> page;
2. Use the cursor keys to move the cursor to the [END MARK] field;
3. According to your own needs, press the function key at the bottom of the screen to
select the desired end mark.
Hand Shake:
After turning on the hand shake, all commands sent by the host to the instrument will be
returned to the host as they are before returning data. After closing the hand shake, the
command sent by the host to the instrument will be processed immediately. (Hand shake
is not used. If there is no special requirements, please set hand shake to OFF.)
