UT3500 series
User Manual
46
Setting Steps:
1. Press the [Test] or [Setup] key, and select [SYSTEM CONFIG] with the function key at
the bottom of the screen to enter the <SYSTEM CONFIG> page;
2. Use the cursor keys to move the cursor to the [HAND SHAKE] field;
3. According to your own needs, press the function key at the bottom of the screen to
select ON or OFF.
Error Code:
After turning on the error code, the instrument will return an error code after receiving the
command. If it is a query command, only the command error will return an error code.
After closing the error code, the host can send the command ERR? To query the error
code generated during the last command execution.
Setting Steps:
1. Press the [Test] or [Setup] key, and select [SYSTEM CONFIG] with the function key at
the bottom of the screen to enter the <SYSTEM CONFIG> page;
2. Use the cursor keys to move the cursor to the [ERROR CODE] field;
3. According to your own needs, press the function key at the bottom of the screen to
select ON or OFF. ON means that the error code will return to the execution error code
after the single-line instruction is executed. OFF means that the error code does not
return automatically.
8.1.10 SCPI [Upload] Mode
The instrument supports the function of automatically sending data to the host. The data
will be automatically sent to the host after each test is completed, without the host sending
FETCH? instruction.
The instrument sends the test result and the comparator result to the host after each test
is completed, please refer to Fetch? subsystem.
Setting Steps:
1. Press the [Test] or [Setup] key, and select [SYSTEM CONFIG] with the function key at
the bottom of the screen to enter the <SYSTEM CONFIG> page;
2. Use the cursor keys to move the cursor to the [UPLOAD] field;
3. According to your own needs, press the function key at the bottom of the screen to
select FETCH or AUTO. The former means to use the command FETCH to obtain all
measurement data, and the latter means to automatically send to the host after each
test is completed.
8.1.11 [Log] and [Stat]
Please refer to Chapter 6 Log/Stat.
