UT3550 Battery Tester Users Manual
25
year, month, day, hour, minute and second that you want to set.
+ means the value plus 1 and
–
means the value minus 1. For example, year+, month+, day+,
hour+, , and rep1 year, +1 month, +1 hour, +1 minute, and +1 second
respectively and vice versa.
7.1.3
AUX SCREEN Setting
Sub-screen has three settings: OFF/ UP/ DOWN
1.
Press
【
Test
】
or
【
Utility
】
key
，
and select
【
SYSTEM
】
to enter < SYSTEM CONFIG > page;
2.
Use the cursor key to move the cursor to
【
AUX SCREEN
】
field;
3.
A
ccording to user’s needs, press the function key at the bottom of the screen to select OFF,
UP and DOWN.
7.1.4
KEY BEEP Setting
The instrument key can set with or withour key prompt sound.
Setting Steps
1.
Press
【
Test
】
or
【
Utility
】
key, and select
【
SYSTEM
】
to enter < SYSTEM CONFIG > page;
2.
Use the cursor key to move the cursor to
【
KEY BEEP
】
field;
3.
A
ccording to user’s needs, press the function key at the bottom of the screen to
select ON or
OFF. ON means that the key beep is on; OFF means that the key beep is off.
7.1.5
BAUD Setting
The instrument has built-in Type-C interface
，
after the instrument senses the signal conversion of the
Type-C interface, it immediately communicates with the host at the set baud rate and the keyboard
is locked.
In order to communicate correctly, it is necessary to confirm whether the baud is set correctly,
otherwise the upper computer cannot communicate correctly.
The instrument with Type-C use SCPI language to programming.
Setting Steps
1.
Press
【
Test
】
or
【
Utility
】
key
，
and select
【
SYSTEM
】
to enter < SYSTEM CONFIG > page;
2.
Use the cursor key to move the cursor to
【
BAUD
】
field;
3.
According to use
’
s needs, press the function key at the bottom of the screen to select differen
baud rates
，
9600, 19200, 38400, 57600, 115200.
4.
To communicate with the host computer, it is recommended to use 115200 high-speed baud
rates.
7.1.6
BRIGHTNESS Setting
The more the brightness is darker, the more the power consumption is lesser, and the instrument
operating time will be longer. The instrument can set 5 brightness level to meets different light needs.
Setting Steps
1.
Press
【
Test
】
or
【
Utility
】
key to enter the main page;
2.
Select
【
SYSTEM
】
key to enter <SYSTEM CONFIG>;
3.
Use the cursor key to move the cursor to
【
BRIGHTNESS
】
field;
4.
Use the function key to select brightness level.
7.1.7
APO Setting
When the test measurement valus is exceed range, no operating, serial port pause to respond and
reach to auto power off time, the instrument will save the data and turn off automatically.
