1. Press the
pushbutton to turn the Calibrator on.
2. Press INPUT to display INPUT if the Calibrator is at output mode which displays
OUTPUT.
3. Press
to select the requested TC type or DC mV range.
4. Insert the test leads to the INPUT terminals as figure 4.
5. Connect the other end of the test leads to the TC simulate equipment or the DC
mV source equipment.
Measuring TC must select the corresponding TC type.
When measuring DC mV, the input voltage must not exceed the present range of
the Calibrator.
When using the TC cable with standard plug to measure temperature, it is necessary
to add an adaptor.
Note:
Model UT713: OPERATING MANUAL
10
