UTD2000 Series User Manual
41
Chapter VIII Cursor Measurement
Use CURSOR to measure waveform X axis (time) and Y axis (voltage). Press CURSOR
to enter cursor measurement menu.
Figure 8-1 Function Key of CURSOR
8.1 Cursor measurement menu
Press CURSOR to enter cursor measurement menu.
Table 8-1 cursor measurement menu
Function menu
Setting
Description
Type
OFF, time, voltage
Set measurement type
Mode
Independent mode, tracking
Select the moving mode of cursor. If independent mode is
selected, only cursor 1 and cursor 2 can be moved. If
tracking is selected, move cursor 1 and cursor 2 at the
same time.
T unit
Second, hertz
Set the unit of time measurement
Source
CH1, CH2, Math
Set measurement source
8.2 Cursor measurement display
On CURSOR mode, user can move the cursor to measure, there are two types: voltage
and time.
Rotate the Multipurpose knob to adjust the position of AY, press Multipurpose knob to shift
cursor BY, adjust BY position with same way.
Set “tracking” with the mode, adajust Multipurpose knob, cursor AY and BY move in parallel.
A,B represent the voltage of coursor AY,BY
B-A represents the voltage difference between intersection of AY and waveform and
intersection of BY and waveform.
When time is measured, the figure below displays on the top left of screen:
