UTG1000A Series 17
3.
Select required unit: Press unit softkeymVpp.
Note: This parameter can be set by multifunctional knob and direction buttons.
3.3.3 DC Offset Voltage Setting
The default waveform is a sine wave with 0V DC o
ffset voltage (with 50Ω termination).Steps for changing DC offset
voltage to -150mV are shown as following:
1.
Press Menu
→
Waveform
→
Parameter
→
Offsetto enter parameter setting.
2.
Use number keys to input the required number of -150.
3.
Select corresponding unit mV.
Note: This parameter can be set by multifunctional knob and direction buttons.
Summary of Contents for UTG1000 Series
Page 2: ......
Page 90: ...88 UTG1000A Series This user manual may be revised without prior notice...
Page 91: ...UTG1000A Series 89...
