12
Never exceed admissible weight capacity of the balancer
— i.e. 60 kg.
IMPORTANT !
Every use of the wheel balancer in a manner contrary to its intended purpose shall entail
the danger of causing serious injuries and accidents.
Therefore, it is particularly significant to strictly apply any and all recommendations
concerning operation, maintenance and safety, stipulated in this manual.
5. INSTALLATION
WARNING !
The following operations may be performed only by persons who were previously trained to operate
the machine to which this manual pertains.
In order to prevent potential damage to the balancer or hazard of causing personal injuries, it is
necessary to carefully follow the instructions below. It must be ensured that no people are present
within the working field.
Requirements regarding installation
The wheel balancer must be installed in the safe distance from walls, columns and other devices.
The site must be equipped in advance with the power supply source and compressed air system.
The wheel balancer may be placed on any even, stable and dry floor.
All the parts must be uniformly lit with the light sufficient to safely perform all the operational,
adjustment and maintenance operations mentioned in this manual. Presence of any shaded areas,
light reflections and blinding light is inadmissible; any situations which may cause eye strain should
be avoided.
Lighting must be installed in accordance with the regulations applicable in the place of installation
(the lighting contractor shall bear this liability).
Prior to installing, all the parts must be unpacked and inspected for any signs of damage.
Issues regarding manoeuvring and lifting are discussed in the chapter “Packaging,
transportation and storage”.
Installation place
The wheel balancer TROLL - 2305H must be installed in a closed and dry place which will be
heated in the autumn and winter period. The machine should be installed on a stable level
floor. The wheel balancer should be installed on four rubber pads enclosed which should be
placed under the flat legs welded to the machine base.
The machine should not be
screwed to the floor.
