17
6.1.4 Balancing programme selection.
Press
. On display marker stops in front of pictogram (a) or (b). Select the programme by
pressing
or
.
Variant a) Dynamic
balancing by two adhesive
weights.
Variant b) Static balancing
(for thin rims by one
weight). This variant is not
recommended for wheels
wider than
2,5”.
6.1.5 Accuracy.
Press (Q). Marker (<) stops in front of pictogram (Q). The balancer has three accuracy level:
2 g, 5 g, 10 g. Pressing (+) or (-) we increase or decrease accuracy. When result is lower
than accuracy level set display shows 0.
ATTENTION !
If we press and hold (STOP) and then press (Q) we will switch the accuracy level off [value
Q=0].
6.1.6 Balancer memory / User memory
Balancer has two memories: M1, M2 which make possible to memorize the parameters for
two wheels. To insert data into memory M1: set parameters (width, diameter, set-off, ALU),
push and hold
pressing simultaneously
. To read previously recorded in
data
press
. For memory
- proceed by analogy.
