23
6.2.1 Imbalance recalculation
This function enables to quickly obtain the correct values of imbalance in the event when
the measurement was performed upon entry of incorrect parameters of a wheel.
Example:
Incorrect data regarding the wheel to be balanced are entered to the machine’s
memory. The measurement is performed, but the results are not true. If one wants to
know the real values of imbalances for this wheel without the necessity to perform
another measurement, it suffices to enter correct data
to the
machine’s memory and press the button The wheel balancer will display correct
values of imbalances.
6.2.2
“Hidden weight” programme
The “hidden weight” programme is used when the user wants the correction weight for
the outer side of the wheel not to be visible in ALU programmes (variant 5 and 6). The
programme enables to split the imbalance displayed in the indicator screen between
two correction weights which should be stuck behind two arms of the rim (spokes)
located in the nearest distance to the left and right from the imbalance position.
Procedure of the “hidden weight” programme
1. Select variant
„2” from ALU programme
2. Start measuring cycle
3. If imbalance position is on spoke imbalance should be corrected by two weights
according to the following procedure:
3.1. Position the wheel so the correction place is in the lowmost point of the rim
(sound signal and arrows directed towards each other).
3.2. Press (3P). Display shows 3P and Pt-1 (See the pictogram below).
3.3. Spin the wheel to the left to the position defined in point 3.1 until the spoke
where weight can be placed. To accept this position press (+) .
Balancer’s computer
memorize this position as a place for the first correcting weight. Display shows
„Pt-
2”, that means the place for the second correcting weight should be found.
