22
23
s
Maintenance
In order to ‘get the best life’ out of your Unibor machine always keep it in good
working order.
A number of items must always be checked on Unibor machines.
Always before starting any job make sure the machine is in good working order and that there are no
damaged or loose parts. Any loose parts must be tightened.
Before proceeding with any maintenance work be certain that the power supply is disconnected.
Description
Every operation
1 week
1 Month
Visual check of machine for damage
X
Operation of machine
X
Check brush wear
X
X
X
X
X
Check magnetic base
Check alignment of the machine Check grease
Check armature
Visually check the machine for damage.
The machine must be checked before operation for any signs of damage that will affect the operation of
the machine. Particular notice must be taken to the mains cable, if the machine appears to be damaged
it should not be used, failure to do so may cause injury or death.
Check operation of the machine.
The machines operation must be checked to ensure that all components are working correctly.
Machine Brushes
Should be checked to make sure there is no abnormal wear present (this should be checked at least
once a week if used frequently). If the brush has worn more than 2/3 of the original length, the brushes
should be changed. Failure to do so may cause damage to the machine.
Summary of Contents for E4000 Perm
