Unibor E50 FRV Manual
Original Instructions
Nov 2019
9
9) GEAR SELECTION
The UNIBOR 50 magnetic drill is fitted with a 2-speed gearbox. The gear is used to reduce the
output speed when using larger cutters.
Slide Selector Position
Speed Controller Setting
Level 1
Level 6
/\
200/min
500/min
\/
100/min
265/min
10) EXTENSION CABLE SELECTION
The machines are factory fitted with a 9 ¾ft length of cable having three conductors 16AWG
LIVE, NEUTRAL and EARTH. If it becomes necessary to fit an extension cable from the power
source, care must be taken in using a cable of adequate capacity. Failure to do so will result in a
loss of traction by the magnet and a reduction of power from the motor.
Assuming a normal AC supply of the correct voltage, it is recommended that the following
extension lengths shall not be exceeded:
For 120v supply:
11 ½ft of 3 core x 16AWG
ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE CHANGING CUTTERS.
11) MOUNTING OF CUTTERS
▪
The machine has been made to
accept cutters having 3/4”
dia. Weldon shanks.
The following procedure is to be used when mounting cutters:
▪
With the machine in the upright position, ensure the Arbor Assembly (CA120) is fully
inserted into Arbor Spindle (RDC4009).
▪
Take appropriate pilot and place through the hole in cutter shank. Insert shank of cutter
into bore of Arbor Assembly, ensuring alignment of two drive flats with socket screws.
▪
Tighten both screws using hexagon key.
Slide Selector Positon Up
Slide Selector Positon Down
