2
3
B
EFORE
S
TARTING
(A Nitto Kohki Company
)
Read these instructions carefully before
operating, maintaining or servicing this
tool.
Please keep these instructions in a safe
accessible place.
Read to fully understand and observe
the following safety precautions and
warnings. Careless or improper use of
this equipment may result in serious or
fatal injury.
Always wear eye, head and ear
protection equipment, when using this
tool.
WARNING! Indicates instant possibility
of severe personal injury or loss of life,
if instructions are not followed.
CAUTION! Indications a possibility of
personal injury or equipment damage, if
instructions are not followed.
O
PERATOR
S
AFETY
• Always read the instructions carefully so as to
avoid any injury or damage when unfamiliar with
this equipment.
• Always wear a safety face shield or goggles.
• Wear ear defenders when using this equipment.
• Always wear heavy clothing, boots and gloves.
Do not wear loose clothing, short pants, sandals
etc. and ensure that long hair is tied up above
shoulder length.
• Do not operate this equipment when tired,
ill or under the influence of alcohol, drugs or
medication
• Never allow an inexperienced person operate
this equipment.
• Never operate the equipment in damp, or water
logged area.
• Keep all carry handles and levers free from oil.
• Keep hands away from the cutter when it is
rotating. Ensure that it has stopped rotating and
is disconnected from the power source before
touching the cutter.
• Do not attempt to gain access into the electrical
panel. There is risk of electrical shock.
• Never use a larger diameter cutter than
specified for use with this equipment.
• Do not attempt to connect the equipment to a
power source other than that specified by the
manufacturer.
• Ensure that the cutter being used is sharp and
free from damage.
T
OOL
S
AFETY
• Inspect the entire piece of equipment before
use.
• Replace damaged components, lubricate
where necessary and ensure that all fasteners
are secure.
• Always use a safety chain to secure the
equipment when it is being used above the
ground.• Use only accessories that have been
recommended by the manufacturer. Failure to do
so could result in damage to the tool and may
invalidate the warranty.
WARNING!
Never modify the tooling any way. Do not use
your equipment for any job other than for which
it is intended.
M
AINTENANCE
SAFETY
• Maintain according to the manufacturers
recommended procedures.
• Disconnect the equipment from the power
source before attempting any maintenance.
• Use only genuine replacement components as
recommended by the manufacturer.
T
RANSPORT
AND
S
TORAGE
• Before moving the tool, ensure that the cutter
has stopped rotating.
• Carry the tool with the cutter pointing away
from the body to avoid laceration.
• After use, clean the equipment and it’s
accessories and store in a dry place.
• Store the equipment along with the maintenance
tools in its correct carrying case when not in use.
Page 3.
Warnings and Safety Instructions
Page 4.
Broach Cutting Concept & Technical overview
Page 5.
Machine Parts & Electronic Functions
Page 6.
Preparation & Drilling
Page 7.
Manual Feed & Autofeed
Page 8.
Parts Explosion Diagram
Page 9.
Parts List
Page 10.
Maintenance and recycling
Page 11.
EU Declaration of Conformity
43, Catley Road,
Darnall, Sheffield
S9 5JF. England.
Tel: (0114) 291 1000
Fax: (0114) 242 5905
Website- http://www.unibor.com
e-mail: sales@udce.co.uk
C
ONTENTS
I
NTRODUCTION
Congratulations on the purchase
of your new, lightweight, autofeed
multi-purpose magnetic base drill.
This is a high quality product with
unique features that make it the
perfect solution for your hole drilling
requirements.
