iZak™ User Guide
USB support for Win98SE users
As has been already mentioned, the accompanying CD contains the
“W98SE”
folder that
provides the USB drivers for the Windows 98SE users. The installation procedure can be
done in one of the following ways:
Setup Installation
1. Double click on the "SETUP.EXE" icon
2. When the installation is completed, click "OK" to finish
3. Connect your device and wait for the system to recognize the new hardware
4. Your device is now ready for use
Manual Installation
1. Connect your device
2. The "New Hardware Wizard" will pop up automatically, press "Next"
3. Make sure your CD is inserted correctly and choose "Search for the best driver...", press
"Next"
4. Choose "CD-ROM driver" or specify a location if you saved it on your PC previously,
press "Next"
5. When the driver is found (GENEUIDE.INF) press "Next"
6. After successful installation press "Finish" to close the Wizard
7. Your device is now ready for use
If at any time you get an error, go one step back or cancel and then try again.
If the installation wasn't successful, there will be a question or explanation
mark in the Device Manager. Remove that driver and then try again.
18