5
►
Safety instructions
This appliance is intended to be used only for its specific use.
The manufacturer disclaims any liability for damage caused by abnormal use or abuse.
Children 8 years of age or older and persons with reduced physical, mental or sensory abilities, or lack of
experience and skill may use this appliance, if supervised by a qualified person, or they have received the
instructions for use and safety necessary to understand the risks involved.
Supervise children to make sure they do not play with the appliance; they must not be allowed to clean or
maintain it.
Do not leave packaging elements within reach of children. These elements are potentially a source of danger.
The installation must be done by a qualified technician and following local and national regulations. They are
the only people authorised to access the internal parts of the appliance for maintenance and repair.
Only use the technical and spare parts manuals to ensure correct operation of the machine, and do not
compromise safety.
Access to the service area is restricted to persons with the necessary knowledge of safety and hygiene as
well as practical experience of the appliance.
Leave enough space around the machine for easy use and access if any repair intervention is required.
The appliance
must not
be:
- exposed to elements of the external environment or placed in damp places,
- exposed to a water jet or splashing.
- installed in areas where jets or high pressure cleaners are used.
The appliance
must
be:
- placed on a stable, level and horizontal surface
- used at ambient temperature of 5°C to 35°C (41°F - 95°F), (if it is stored at an ambient temperature below
5°C (41°F), the water circuit (boiler-piping) must be drained).
- if the appliance freezes, wait 24 hours at a minimum temperature of 10°C (50°F) before restarting it.
Before connecting the power and water supplies, check that the electrical and water mains comply with the
technical information plate of the appliance.
The power supply must be provided with the following safety features: power switch which completely isolates
the machine from the mains (gap between contacts of at least 3 mm), efficient earthing and an effective circuit
breaker for protection against earthing leaks; section of the conductors appropriate for a power capacity.
Before connecting or disconnecting the power cable, switch the main switch to position 0.
If the power supply cable is damaged, it must be replaced by the manufacturer, by its after-sales service
technician or similarly qualified persons, to avoid any danger.
For electrical safety, make sure that the appliance is properly earthed.
The manufacturer disclaims any liability for damage caused by improper earthing.
The appliance must be connected to the water mains with a pressure of 1 to 8 bar (0.1 to 0.8 MPa) and a tap
readily accessible must be fitted in front of the water supply tube.
The appliance is to be installed with adequate backflow protection to comply with applicable federal state and
local codes.
In case of an emergency (fire, surge, abnormal noise, etc.), the first thing to do is to cut off the power supply
and close the water tap.
Be careful not to obstruct the air inlets of the machine with cloths or other objects.
Beware of hot surfaces such as cup warmers, the unit heads and the hot water and steam outlets.
Never place containers filled with liquids on top of the machine
Never expose it to hot water or steam jets.
The machine should be descaled only by a qualified technician.
