Installation of containers
WARNING:
DO NOT SMOKE OR USE OPEN FLAME NEAR CABINET.
UGC4006 ONLY Take 1 x 25litre drum of clean solvent, remove 5 litres and
fill an empty 5 litre container.
UGC5006 ONLY Take 2 x 25litre drum of clean solvent, remove 5 Litres
from each drum and fill
2 x empty 5 litre container.
Disconnect quick release coupling by lifting the locking ring and bring
outside of machine (See Diagram 1).
Insert hose with suction filter into drum of solvent and enter drain tube.
Push solvent container/s under machine aligning filler neck with male part
of quick release coupling.
Reconnect quick release coupling.
UGC4006/UGC5006 ONLY Place the full 5 litre container under the centre
of the machine next to the 25 litre drum of solvent and insert black 6mm
nylon tube with wire clip in to the full 5 litre container (Repeat this step for
UGC5006).
Turn drain valve lever to vertical position (see diagram 2).
Underneath the machine at the rear are the earthing wire(s), the crocodile
clip(s) must be attached to any metal solvent container(s) if used (these are
not supplied by Unic international).
1
2
3
4
5
6
7
