6
6.3 - OPERATION
Domestic hot water production
Make sure that on the display
E
( ) is lit up, select the mode via
B / C.
By adjusting the temperature of the domestic hot
water at a temperature very close to that actually
used, you will avoid mixing hot water with cold
water, with management savings and significantly
reducing the formation of limescale.
By opening a hot water tap, the
appliance is automatically activat
-
ed and delivers water at the set
temperature.
During the sampling stage, the dis
-
play shows the temperature of the
domestic hot water and the symbol
(
) flashes.
Heating
discharge
Make sure that on the display
E
is
lit up ( ), select the mode via
B / C.
During operation in heating mode,
the display shows the water tem
-
perature and the symbol (
)
flashes.
Antifreeze protection only
Make sure that E is lit up on the
display
(
), select the mode using B
/ C.
The antifreeze protection inter
-
venes
only if the boiler is powered
electrically and if the gas valve is
open.
If for some reason there is a power
or gas failure, the antifreeze protec
-
tion described above is not active.
Complete decommissioning
To decommission the system,
disconnect the boiler from the
power supply by acting on the main
switch.
In the event of complete decom
-
missioning, the heating and hot
water production modes as well
as the antifreeze protection are
completely disabled.
If idle for long periods, close the
gas shut-off valve and cold water
cock, if present
.
Summary of Contents for Kone R 24
