01865 767676
sales@unicol.com
www.unicol.com
6
Revised 08/11/19
STEP 15
Before fitting the last 2 rear in-fill panels, identify
the fold down shelf. Angle the shelf so that the
clips go between the columns and then level out -
allowing it to rest on the in-fill panel below.
STEP 14
Cable up and then identify remaining mast in-fill
panels. Start from the bottom and clip 2 of the 3
larger rear panels in, threading cabling through
where necessary.
STEP 16
Clip the last rear in-fill panels into place to finish
the assembly.
STEP 13
Identify mast in-fill panels (the 4 with cut-outs go
to the rear). Start from the bottom and clip the 4
front panels in, one on top of another (with the
smaller 15cm panel at the top).
Please note; the panel with the 4-way power
socket should be located at the bottom.
