01865 767676
sales@unicol.com
www.unicol.com
4
Revised 25/10/19
STEP 7
Locate the top cover and clip into place.
Please note; this is held on magnetically and does
not need screwing into place.
STEP 5
Locate the bottom cover and slide it into position.
The open end should be facing down and the two
small cutouts facing up. This will allow you to slide
over the fixing screws.
STEP 6
Looking underneath the bottom cover, tighten the
two fixing screws. Ensure that the cover is flush
with the bottom of the screen.
75 mm
Drill 11mm Dia hole through
upright inner side
FOR REFERENCE
Upright mount grub screw hole
Note: You can shorten the unit by cutting the up-
rights to the desired height from the bottom. Drill a
new hole to access the base mounting post grub
screw - see Fig A
Fig A
