ENDAT
‐
N3410
User’s
Manual
UNICORN
COMPUTER
CORP.
Copyright 2015 Unicorn Computer Corporation. All rights reserved.
14
2.2.
2.2.
System Memory
The board has two 204-pin SO-DIMM sockets and supports the following memory features:
•1.35 V DDR3L up to 1600 MHz SDRAM SO-DIMM with gold plated contacts on Intel Celeron processor N3000
series.
•Support for 1066 MHz/1600 MHz memory speeds
• Dual memory channel
• Unbuffered, single-sided or double-sided SO-DIMMs
• Each channel was up8 GB maximum total system memory (with 4 Gb memory technology). Refer to Section
BIOS SETUP on the total amount of addressable memory.
•
Minimum recommended total system memory: 1024 MB
•
Non-ECC SO-DIMMs
•
Serial Presence Detect
NOTE:
If you install 1333 MHz, it will run at 1066 MHz
Supported Memory Configurations SO-DIMM
Capacity
Configuration
(Note)
SDRAM Density
SDRAM Organization
Front-side/Back-side
Number of SDRAM
Devices
1024 MB
SS
1 Gbit
128 M x8/empty
8
2048 MB
DS
1 Gbit
128 M x8/128 M x8
16
2048 MB
SS
2 Gbit
256 M x8/empty
8
4096 MB
DS
2 Gbit
256 M x8/256 M x8
16
4096 MB
SS
4 Gbit
512 M x8/empty
8
8192 MB
DS
4 Gbit
512 M x8/512 M x8
16
Table 3: list the supported SD-DIMM configuration
NOTE:
To be fully compliant with all applicable DDR SDRAM memory specifications, if non-SPD memory is installed, the
BIOS will attempt to correctly configure the memory settings, but performance and reliability may be impacted or
the SO-DIMMs may not function under the determined frequency.
