5
Follow the procedure described below to attach
the needle, after confirming that the motor has
come to a complete stop.
Select a proper needle size according to the
count of thread and the type of material used.
1)
Turn the handwheel until the needle bar
reaches the highest point of its stroke.
2)
Loosen screw
➋
, and hold needle
➊
with its
indented part
Ⓐ
facing exactly to the right in
direction
Ⓑ
.
3)
Insert the needle fully into the hole in the
needle bar in the direction of the arrow until
the end of hole is reached.
4)
Securely tighten screw
➋
.
5)
Check that long groove
Ⓒ
of the needle is
facing exactly to the left in direction
Ⓓ
.
1)
Hold the bobbin in a way that the thread open
end is directed to the left as observed from
you, and set the bobbin into the bobbin case.
2)
Pass the thread through thread slit
Ⓐ
, and pull
the thread in direction
Ⓑ
. By so doing, the
thread will pass under the tension spring and
come out from notch
Ⓑ
.
3)
Check that the bobbin rotates in the direction
of the arrow when thread
Ⓒ
is pulled.
5. ATTACHING THE NEEDLE
WARNING Turn OFF the power before starting the work so as to prevent a accidents caused
by abrupt start of the sewing machine.
6. SETTING THE BOBBIN INTO THE BOBBIN CASE
Summary of Contents for H5600-D
