18
PG-I Series | Version 1.03
Operation
9.1.2PG-I 35 SR
Cable start
Step 1: Check oil and fuel and top up if necessary.
Step 2: Open the filler cap vent.
Fig. 26: Venting tank cap
Step 3: Turn the knob for the fuel tap to "ON".
Fig. 27: Open fuel tap
Step 4: Turn the motor switch to the "ON" or "RUN" posi-
tion
Fig. 28: Operate motor switch
Step 5: Turn the choke lever to the "CHOKE" position
Fig. 29: Actuate choke
Step 7: Slowly pull the pull starter until resistance is felt.
Then jerk the pull starter.
Fig. 30: Pullstarter
Step 8: Warm up the engine until it runs smooth and
round.
Step 9: Push the choke lever back to the "RUN" position.
Fig. 31: Actuate choke
Electrical start
Step 1: Open the tank cap vent.
DANGER!
Never start or stop the engine when electrical
appliances are connected.
Disconnect all electrical appliances from the genera-
tor before starting.
Check that the generator is level.
Engine
switch
Engine
switch
