10
TWG 1 | Version 1.02
Commission
Step 3: Connect the parts washer to the power supply
and switch the device to "ON" at the power
switch. (Fig. 7)
Fig. 7: Switch on the Part Washing Unit TWG 1
Step 4: Place the component to be cleaned in the parts
washer and close the door. Use the washing gun
(Fig. 8) to clean the component. To clean with
solvent, press the red lever. To clean or bleed
with compressed air, press the black lever.
Fig. 8: Cleaning with the washing gun
Step 5: Open the door of the parts washing machine and 0re
-
move the cleaned component. Switch off the com
-
ponent washing device by the ON / OFF switch.
Step 6: If the detergent is heavily soiled, replace it.
Check the filter at regular intervals and clean if
necessary. (Fig.9)
Fig. 9: Filter screen Part Washing Unit
ON / OFF
Switch
Cleaning supplies
ON / OFF
Compressed air
NOTE!
Before using the parts washing machine for the first
time, carry out the following points.
- Check all screw connections on the assembled
parts washing device and tighten them if necessary.
- Check the parts washing machine for leaks.
ATTENTION!
The washing gun must always be directed away from
the operator. Never work with the door open on the
part washing machine.
