Page 36
Version 3.3 / November 2016
To program the lock by other working key (for example, to use one working key for multiple machines
or operating loss of key) you must perform the following operations when you open the door machine:
• Insert the master key lock (‘‘closed’’ position - see figure 74) in which the castle was the last time that
programmed or is supplied with a lock (for primary programming). Lock master key in the lock at least
one second. Then turn 90 degrees in the direction of the control key risk (see figure 74).
•
While holding shutting off device of the door in order to avoid a spontaneous turn of the lock, remove
the master key from the lock and insert them into the new master key , which you want to program
the lock. If you want to program the lock on the same master key, don’t remove the master key from
the lock.
• Then turn the master key 90 degrees in the opposite direction (the ‘‘closed’’ position -see figure 74).
•
Remove the master key from the lock and put it in a safe place. To open / close the lock, use the op-
erating keys, coming complete with a new master key.
