Entries may be one or two lines, therefore the scroll keys will move the
display UP or DOWN one or two lines, depending on whether the Entry is
two lines or not.
2.8.2
Auto Key Repeat
When a key is held down, it automatically repeats. This is a quick way to scan
up or down a list of display entries. Releasing the key stops the repeat mode.
2.8.3
Adjusting a Config Entry
To alter a logger Config Entry, scroll to the desired Entry in the Config List
and use the Adjust keys
34
to adjust the Config Entry to the required
settings, then press ENTER to save the new setting permanently. If you do
not want to save the Config Entry, press any other key (or no keys at all).
Warning: Pressing the Enter key while displaying a Config Entry with the
message ...use & ENTER on Line 2 will cause data stored in memory
above 64K to be lost.
2.8.4
Commands in the Config List
Some entries in the Config List are simple commands, they do not use the
Adjust keys
34
and they do not cause loss of memory when executed
(when ENTER is pressed). A useful command “TURN DISPLAY OFF” is
the first entry in the Setup List. Therefore, whenever you have finished
viewing the display, press CONFIG, and then ENTER keys.
The display will automatically turn OFF anyway after 20 seconds if no keys
are pressed.
2.8.5
Using a PIN# (Password)
The PROLOGGER is fitted with a keyboard and display. This enables you to
configure various functions of the logger without a computer. To ensure that
only authorised users alter the operation of the logger, an optional 4-digit
PIN# (personal identification number) may be entered. The factory default for
the PIN# is 0.
UNIDATA
10 PROLOGGER OVERVIEW
Summary of Contents for Starlog Prologger 7001
