10.1.1 Task Command List
n
ANALOG
A
Continuously convert and display single ended channels A0...A7.
B
Continuously convert and display single ended channels A8...A15.
F
Select differential signals.
H
Select High level signals GAIN = 1 (0–5.00.V).
I
Continuously convert and display temperature and battery
readings.
L
Select Low level signals GAIN = 100 (0–50mV).
M
Select Medium level signals GAIN = 10 (0–500mV).
E
Select Extra Low level signals GAIN = 1000 (0–5mV).
n
CONTROL
K
Kill (exit from) Diagnostic Mode. Resets logger.
S
Sleep. Shut down logger to conserve batteries when the logger is
left unused for long periods.
Warning: logger will be left in an uninitialized state and will not scan. The
User must reset the logger using the Issss command (or reload the logger
with a valid Scheme).
n
COUNTER
Y
Continuously read and display four Counter channels in hertz
(frequency mode).
T
Continuously read and display four Counter channels in binary.
Type any character to stop continuous conversion mode.
n
INPUT/OUTPUTS
J
Display Binary inputs UIN0/UIN1.
O
Set Binary output UOT1/(LEDs), UOT0(CNTL), UOT2(ANLG).
V
Test HSIO OUT0 (pulse output).
n
KEYBOARD/DISPLAY
D
Test LCD display.
UNIDATA
52 TEST DIAGNOSTICS
Summary of Contents for Starlog Prologger 7001
