Announce only feature:
The announce only feature plays an outgoing message, but it
will not allow the caller to leave a message. Move the
REC
TIME
switch to the
ANN
position.
The message counter LED displays
when the system is
on standby.
Pre-recorded outgoing message for Announce only feature is:
“Hello, no one is available to take your call.” (twice)
Selecting Ring Time Switch:
The ring time/toll saver switch allows you to set the number of
rings the caller hears before the answering system plays your
outgoing message.
You can set the switch to answer after two rings or after four
rings. Once the greeting has started, you can stop it when you
pick up the call at the handset or base. In the
TS
(toll saver)
position, the answering system picks up after 6 rings if you
have new messages, and after 9 rings if there are none.
This way, if you call long distance to check your messages,
you can hang up after the seventh ring to avoid billing charges.
Selecting a PIN code:
To play your messages from a remote location, you will need to enter a two digit Personal
Identification Number (PIN) code . To select a PIN, perform the
following steps.
1. On the base, press and hold until a tone sounds and the LED displays
00
.
2. To set the first number, press or repeatedly to scroll from 0 to 9. When
the desired number appears in the display, press .
3. To set the second number, press or to scroll from 0 to 9. When the
desired number appears in the display, press . Then the entered PIN code is
announced.
pin
pin
pin
RING TIME
2/4/TS
REC TIME
ANN/4/1
20
(
(
9
9
0
0
Using Your Answering System
Playing your messages
The base LED shows the number of total messages on the display. If the display is blinking,
then there are new messages waiting for you. After you play your new messages you can then
play old messages.
1. Press
. The system announces the number of new and old messages, then the
incoming messages are played.
2. When all new messages have played, a tone is heard. The message counter LED stops
flashing to indicate that all of the new messages have been reviewed.
3. After you have reviewed all your messages, you can play your old messages again. Press
and follow the instructions above.
Selecting the message record time:
You can set your answering system to record a message up to one or four minutes long.
One minute option : move the
REC TIME
switch to
1.
Four minutes option : move the
REC TIME
switch to
4.
volume
voice memo
greeting
speaker status
delete
play
RING TIME
2/4/TS
REC TIME
ANN/4/1
