91
If you have 3-line or 4-line in a jack, then you need a splitter* before
connecting. You can also have your telephone service provider to rewire for
you.
After all lines are connected, you can connect the console to the power
outlet. Place your six desksets, and connect them to power outlets. They
will wirelessly connect to the main console. Now, you can follow the User’s
Manual to register the phones.
Top questions for operations
My console doesn’t work at all.
Make sure the power cord is securely plugged in.
Make sure you plug the telephone line cord(s) securely and firmly into the
console and the telephone wall jack.
Reset the console. Unplug the electrical power. Wait approximately 15
seconds, then plug it back in. Allow up to one minute for the console to
reset.
Other electronic products such as HAM radios and other DECT phones, can
cause interference with your cordless phone. Try installing your phone as far
away as possible from these types of electronic devices.
You may need to purchase four AA alkaline batteries as backup battery
to make the console work in the event of a power failure. Please refer to
Backup battery installation
on page 2 in this user’s manual.
I cannot get a dial tone or cannot dial out.
Make sure you have a dial tone before dialing. The corded handset might
take a second or two to connect to the console and produce a dial tone. This
is normal. Wait an extra second before dialing.
Eliminate any background noise. Noise from a television, radio or other
appliances might cause the telephone to not dial out properly. If you cannot
eliminate the background noise, first try muting the corded handset before
dialing, or dialing from another room by a cordless handset with less
background noise.
If the other telephones in your building are having the same problem, contact
your telephone service provider.
My console does not ring when I receive a call.
•
•
•
•
•
•
•
•
•
•
Frequently asked questions
