Troubleshooting
If your
BC60XLT-1
is not performing properly, try the
following steps.
Problem
Suggestion
Scanner won’t work.
1. Check the connections at both ends of
the AC Adapter.
2. Turn on the wall switch of your room. You
could be using an outlet controlled by the
wall switch.
3. Move the AC Adapter to another wall
outlet or replace the batteries.
Improper reception.
1. Check the antenna connection or move
and reposition the antenna.
2. Move the scanner.
3. You may be in a remote area which could
require an optional multi-band antenna.
Check with your dealer or local
electronics store.
Scan won’t stop.
1. Adjust squelch threshold - refer to
page 10,
Setting the Squelch.
2. Check the antenna connection.
3. Check to see if many of the channels are
locked out. If so, the scanner has less
chance of finding an active channel.
4. Review each channel’s frequency to see
if it is still stored in memory and is correct.
5. It’s possible that none of the programmed
frequencies are currently active.
Scan won’t start.
1. Press the
S
key again.
2. Adjust the SQUELCH control.
3. Check to see if all channels are locked
out.
Weather Scan won’t work.
1. Adjust squelch threshold - refer to
page 10,
Setting the Squelch.
2. Check the antenna.
If you still cannot get satisfactory results and want
additional information, or to return the unit for service,
please call or write the Uniden Parts and Service Division.
The address and phone number are listed in the Warranty
at the end of this manual, or call 1-800-297-1023.
33
