45
7. If you selected
ED-SCT
in Step 3, stop here.
Otherwise, if you selected
ED-HI
or
ED-LO
in Step 3, follow these steps to enter the
talk group ID (agency, fleet, and subfleet) for the system you want to scan.
a. Press
DATA
.
b. If necessary, turn the rotary tuner or repeatedly press
HOLD
U
or
LIMIT
V
until
PRO9 ID
appears. Then press
E
on the keypad.
c. Turn the rotary tuner or repeatedly press
HOLD
U
or
LIMIT
V
until the talk group ID
memory location where you want to store an ID appears.
d. Use the keypad to enter the agency, fleet, and subfleet, then press
E
. (Press
.
to
enter the hyphen).
e. To enter additional IDs, repeat Steps c-d.
Programming LTR Systems
1. Hold down
TRUNK
for about 2 seconds. The scanner beeps and
BANK
,
TRUNK
, and
the bank letters A-J blink.
2. Press a bank key to select the bank where you want to store the frequencies.
3. Select LTR scanning by turning the rotary tuner or repeatedly pressing
HOLD
U
or
LIMIT
V
to select
LT
. Then press
E
on the keypad.
4. If necessary, repeatedly press
HOLD
U
or
LIMIT
V
until
PRO9 F
appears. Then press
E
on the keypad.
5. To enter trunking frequencies, use the keypad to enter the first frequency, then press
E
on the keypad.
(Press
.
to enter the decimal point).
Note
: To clear a mistake while entering a frequency, press
.
twice then enter the
frequency again.
6. For each additional frequency, select the next channel by turning the rotary tuner or
pressing
HOLD
U
. Then use the keypad to enter the next frequency, then press
E
on
the keypad.
(Press
.
to enter the decimal point).
7. Follow these steps to enter the talk group ID (agency, fleet, and subfleet) for the system
you want to scan.
a. Press
DATA
.
b. If necessary, turn the rotary tuner or repeatedly press
HOLD
U
or
LIMIT
V
until
PRO9 ID
appears. Then press
E
on the keypad.
c. Turn the rotary tuner or repeatedly press
HOLD
U
or
LIMIT
V
until the talk group ID
memory location where you want to store an ID appears.
d. Use the keypad to enter the agency, fleet, and subfleet, then press
E
. (Press
.
to
enter the hyphen).
e. To enter additional IDs, repeat Steps c-d.
