71 for instructions.
STEP 1 is complete.
Note:
Information on APCO P-25 Systems are referred to in
“APCO Project 25 Reception” on page 76.
STEP 2:
Programming Trunking Frequencies
After you finish selecting the bank and trunk type you want to
track, store the frequencies in the channels for your selected
bank in your scanner. Remember that you can only store one
trunking system in each bank.
Important
: If you are programming an EDACS or LTR
trunked system, you must enter the frequencies
in a specific order. Check the frequency guide
included with the scanner for the frequencies in
your area. For additional frequencies, check the
web sites listed on page 11.
1. Press
MENU/BACK
.
2. Select
2:SCAN OPTION
/
2:TRUNK
by rotating the
VFO
and
pressing
E
.
3. Select the bank number by rotating the
VFO
and pressing
E
.
4. Select
2:TRUNK CHANNEL
and
enter the channel number by rotating the
VFO
and
pressing
E
.
5. Select
1:FREQUENCY
and enter a frequency for the
trunked system using the keypad and pressing
E
.
6. Enter the alpha tag and press
E
. (See page 53).
7
You can also change the step size in this menu.(See page
103)
Note
: • To clear a mistake while entering the frequency,
50
HOLD/
MAN
SCAN
CH/
FRQ
MENU/BACK
L/O
.
SELECT
REVERSE
TRUNK
RSM
E
SEARCH
SERVICE
No. LCD display
Icon
TrunkingType
Special requirements
1
Type 2 800
M
Motorola Type 2 800 MHz
2
Type 1
M
Motorola Type 1
a. Must program a fleet map.
3
Type 2 900
M
Motorola Type 2 900 MHz
4
Type 2 UHF
M
Motorola Type 2 UHF
b. Must program base, spacing,
5
Type 2 VHF
M
Motorola Type 2 VHF
frequency and offset channel.
6
EDCS WIDE
E
EDACS Wideband 9600 baud
c. Must program frequencies
7
EDCS NARROW
E
EDACS Narrowband 4800 baud in exact order and location.
8
EDCS SCT.
E
EDACS SCAT
9
LT L
LTR
BC250D 11/6/2 11:37 AM Page 50
